Cable Puller

The Li'l Tugger Cable Puller takes much of the time and physical strain out of long, difficult wire pulls normally done by hand. It produces a pulling speed of up to 60 feet a minute (18 meters per minute) in small-diameter conduit with minimal effort. The physical strain and potential for operator injury associated with long, difficult runs pulled by hand can be reduced. In addition, the puller can reduce job costs to a fraction of what's required when pulling by hand, says the company.

It consists of a 4-piece assembly that weighs 20 lbs. and can be set up in minutes. Its pulling power is supplied by a standard Milwaukee "Hole Hawg" (not included), which slides into the frame and drives the capstan that the pulling rope wraps around. The operator wraps the pulling rope around the capstan several times, turns the power switch to ON, and begins a pull. It is adjustable to fit into small boxes mounted at different heights, and can be moved from one pull to another without disassembly.

Greenlee Textron, 4455 Boeing Drive, Rockford, Illinois 61109-2988 Phone: 815-397-7070 Fax: 815-397-1865